Layout jumping during scanning

  • Resolved Bahus

    (@bahus)


    1 week, 1 day ago

    When a scan starts, the current scan path is displayed above the results table. If the path fits on one line on the screen, then everything is fine. however, if it wraps to two lines, the results table shifts downward.

    When scanning, if the current addresses quickly change from single-line to double-line and back, the results table “jumps” up and down.

    I use a small, older 17-inch monitor, so long paths don’t fit on a single line, causing the table to constantly shift vertically. This happens on all my websites. This means it’s a display issue on older, non-widescreen monitors.

    It’s very hard on the eyes. Can this be fixed?

    • This topic was modified 1 week, 1 day ago by Bahus.
Viewing 2 replies - 1 through 2 (of 2 total)
  • Plugin Author Eli

    (@scheeeli)

    1 week, 1 day ago

    Thank you for this suggestion. I think that would be a relatively easy fix and it would certainly be a visible improvement to the UI, so I will definitely incorporate a fix for this issue into my next plugin update.

    It is a common curse of the web-developer to not take into account all the many different interface options of every user, so I really appreciate how you brought this to my attention. Thanks again!

    Thread Starter Bahus

    (@bahus)

    1 week, 1 day ago

    Thank you. Have a good day.

Viewing 2 replies - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.