• Resolved allanmartel

    (@allanmartel)


    I seem to be having an issue with an AI form output that starts out fine, but then eventually turns into complete gibberish. At this time, it appears to be only with xAI grok 4.5, whether I choose the model directly from xAI or through Openrouter.

    I am assuming this is probably an xAI issue, but I cannot seem to replicate it using xAI directly.

    Any thoughts?

    Example output: It will start off 4 or paragraphs of normalcy then all of a sudden start displaying stuff like this:

    olumbus consistentlystellungen ranks among the most buyer -friendly large Midwest marketset scaler thanks Heel to high affordability, Ers crisis diversified job growthFalling, N and can growing inventory son that alloy betterInnov matches̑ local拮 incomes.정 Median g way values inexpensiveNearestCITYレディ typicallyデザイン sit proiect nearRIA or just péntrissimi above $250 extremely000-radius$300,000바와s, with healthy pagioside activityคว and labels nearby large sinks universities,, logistics hubs anvien techonia investments supportingבת demand.

Viewing 3 replies - 1 through 3 (of 3 total)
  • Plugin Author senols

    (@senols)

    This sounds like “temperature” issue. Can you check its value and make sure its 1?

    Thread Starter allanmartel

    (@allanmartel)

    I checked and it was set to 1.2. I reset to 1 and will test tomorrow. I marked as resolved for now.

    Thanks!

    Thread Starter allanmartel

    (@allanmartel)

    The issue appears to be resolved, thank you!

    If you read this, what exactly does the temperature setting do that would cause that issue? The documentation states it “Controls response variation”, but not much else.

    How much can it really be adjusted without causing an issue? If changing from 1 to 1.2 is enough to cause an issue, is there a point to using it at all?

    Just curious. Thanks again!

Viewing 3 replies - 1 through 3 (of 3 total)

You must be logged in to reply to this topic.