Hi @bilalassem,
There is a “separator height” control for this. Please see this screenshot:
https://screencast.com/t/KhmCSyYYW2lo
Did that not work for you?
Thread Starter
Assem
(@bilalassem)
Hi Horearadu,
Actually, I really meant to reduce the whole header, the seperator makes only changes in the shape smaller or bigger.
To make my issue clear, you can go to my website officehero.nl.
I have chosen a shape with the separator height control it is only possible to make the shape on one side smaller. I want to reduce the whole shape, so the shape is not shown like now at the whole page.
Hi,
I’m not sure I understand what you mean by:
“I want to reduce the whole shape, so the shape is not shown like now at the whole page.”
I’m guessing you want to make the whole header smaller in height? Is that correct?
You can use the content spacing values to reduce the height of the content. Please see this screenshot:
https://screencast.com/t/nQi7WKRm9
Is that what you’re looking for?
Thread Starter
Assem
(@bilalassem)
Hi, thanks for your reply.
That’s what I’m looking for.
But I want to reduce it even further. For example, by tumbling -10%.
The minimum content spacing value is 0%. I want to reduce the header content to the red section. It would be nice if I could also enter negative values%.
Please see the screenshot below:
https://screenshot.net/nl/w2789i9
Thank you in advance for your help
Hi @bilalassem,
The problem is that right now there is a minimum value there, even if you set it to 0%.
We will remove that minimum in the next update. The update will be available in about 1-2 weeks.
Would that be ok for you?
