Page navi slider
[resolved] Control width of the slider to fit the column (5 posts)

  1. cryogenn
    Posted 2 years ago #

    Hi, is there any way to control the width of the slider when it appears in the footer?

    I used your auto-display and it appeared at the bottom of my page fine. However, the slider stretches across the whole width of the page.

    So it is under column 1, 2 and 3 but my content is only in column 2

    Is there any way to have the plugin just under column 2?


  2. cryogenn
    Posted 2 years ago #

    Or if it is possible to center the plugin on the page but then have it take up xx% of the page width.

    My theme has a column layout by percent option where I can use 20% left hand column, 60% middle and 20% right hand column.

    So whether you want to use numbers or a percent or both, I just need to find some way to keep the slider to the middle column and dictate how much of that space it takes up.

    Perhaps someone else might like to keep the slider just to the right or left column only, so an option for that too if someone else found it useful

  3. Iznogood1
    Plugin Author

    Posted 2 years ago #

    Hi cryogenn,

    Have you tried to set-up the wrapper margin (in the General settings tab) to
    0 20% 0 20% ?

    You can also not use the auto-display feature, but just instert the code after the WordPress loop.

  4. cryogenn
    Posted 2 years ago #

    Hi, thanks for pointing that out. I was starting at the "0.833em" part but didn't see the line you had above about adjusting the percentage.

    That did solve the problem.

    Also, you have a small typo on that page "plugin widht" where it should be "width" of course.

  5. Iznogood1
    Plugin Author

    Posted 2 years ago #

    Oops !
    I'll fix it in the next release.


Topic Closed

This topic has been closed to new replies.

About this Plugin

  • Page navi slider
  • Frequently Asked Questions
  • Support Threads
  • Reviews

About this Topic