Support » Plugin: AMP » Activating AMP plugin in Reader mode crashes Gutenberg

Viewing 7 replies - 1 through 7 (of 7 total)
  • Thanks for reaching out and providing the additional information. Can you follow the steps below and try to edit a post once more?

    1. Install and activate the Health Check & Troubleshooting plugin.
    2. Navigate to “Plugins > Health Check & Troubleshooting > Troubleshoot”.
    3. From the same screen click on the “Available Plugins” tab at the top right and then click on the “Enable” option next to “AMP”
    4. Attempt to edit a post once more

    If you are able to edit a post then you can activate other plugins once by once while in troubleshooting mode, while trying to edit a post each time.

    If you’re still unable to edit a post can you share whether this only started to occur after updating to the latest version of the plugin?

    You can exit troubleshooting mode afterwards.`

    Plugin Author Weston Ruter

    (@westonruter)

    @yanch Yes, going through this Troubleshooting workflow will be extremely helpful since you have 34 plugins active. If you start with just the AMP plugin active, I presume that you’ll get no error in the editor. If you can then enable each plugin one-by-one and re-check the editor, you should be able isolate which plugin specifically is causing the compatibility problem. Then we’ll be identify if the problem is with that plugin or a problem with the AMP plugin/

    I don’t see any error in the editor myself.

    Thanks!

    @yanch Just following up to check whether you’ve had an opportunity to run through the suggest troubleshooting steps?

    Thread Starter yanch

    (@yanch)

    @jamesosborne
    Hi! Sorry for the delay.
    I did that just yesterday and it took a few hours and the troubleshooting mode wasn’t very stable.
    For now, I made a conclusion that as I deactivated “Make Paths Relative” plugin – all works.
    So there is something in that that caused some error, mb inside the theme JS as I also saw today (mb it’s a different thing) “can’t build URL” in the console.

    Many thanks for the update. I’ll check the same “Make Paths Plugin” myself. Can you confirm all is working once deactivated?

    Thread Starter yanch

    (@yanch)

    Yes, it’s all working once deactivated. But I have an assumption as it might also cause errors with our themes JS, as it was an error there. But still, it was an error for the editor itself (so 2 errors in the console)

    Thanks for the update. I tested the Make Paths Relative plugin and I wasn’t able to recreate the same experience. If you find any particular conflicts with your theme feel free to share any findings here, or use the “Health Check & Troubleshooting” plugin.

Viewing 7 replies - 1 through 7 (of 7 total)
  • The topic ‘Activating AMP plugin in Reader mode crashes Gutenberg’ is closed to new replies.