Forums

Meteor Slides
Publishing message error (8 posts)

  1. rrosen1
    Member
    Posted 7 months ago #

    I have installed meteor slides and the banner is waiting for my slides. I have uploaded about 3 to test and when I hit publish I get the following message.

    the has unresolved errors. Empty the queue to restore normal operation.
    When I empty the queue I get the same message

    http://wordpress.org/extend/plugins/meteor-slides/

  2. JLeuze
    Member
    Posted 7 months ago #

    That's a strange message, I would deactivate any other plugins you have activated to rule out any plugin conflicts. What theme are you using, could you post a link to the site you are working on?

  3. rrosen1
    Member
    Posted 7 months ago #

    I did have a problem with plug ins so they were all deactivated.Then I activated far fewer than I originally had. I then started to re-install Cimy Header Image Rotator that I used before and had a lot of sizing errors that I didn't have the last time I used it. Your plug in was recommended by Aquid Forum. I am using their Suffusion theme. For some one with little or no HTML experience it has done well by me.
    http://www.appleledgephotography.com . You will see that the space for the slide show is in place.
    Thank you
    Bob

  4. JLeuze
    Member
    Posted 7 months ago #

    Thanks for the info Bob, to load the slideshow, make sure that the shortcode has square brackets like this:

    [meteor_slideshow]

    Did you test Meteor Slides when you had all your plugins deactivated? I would try publish a slide with all the other plugins deactivated and see if you still get this error.

  5. rrosen1
    Member
    Posted 7 months ago #

    Working great! Thank you. I don't know why but I think the conflict could be Lazy Gallery that is one of the plug ins I disabled. I also added the brackets. Any recommendation on reactivating the plugins?

  6. JLeuze
    Member
    Posted 7 months ago #

    That's good, just keep activating them until it breaks again and you'll have your culprit!

  7. rrosen1
    Member
    Posted 7 months ago #

    I only activated a few and the message is back. I am however able to publish slides. So I'll keep working on it. Thank you. Send me the link to buy you a coffee please.

  8. JLeuze
    Member
    Posted 7 months ago #

    Thanks Bob, here's the link!

Reply

You must log in to post.

About this Plugin

About this Topic